Five Common Methods For Kitchen Exhaust Cleaning

Five common methods for kitchen exhaust cleaning

Recently, some clients asked us about the methods of cleaning kitchen exhaust ducts. In order to solve everyone's questions, today we specially sorted out five common methods of cleaning grease ducts. Next, follow us to learn about it.

1. Method two for cleaning grease ducts: people entry

This method is suitable for horizontal ducts bigger than 40 cm in height to be cleaned by people entry. This method is more labor intensive, and attention should be paid to ventilation and low-pressure lighting equipment.

2. Cleaning method three of grease ducts: disassemble

When there is no way to enter the ducts by people, the disassembly method can be used. This method is the most thorough cleaning method, but the construction is more difficult, requires a lot of labor, and the cost is high. According to the actual situation of the ducts, the technician first calculates the distance difference of the disassembly, and then extends it to clean on both sides.

3. Cleaning method one for grease ducts: open holes

This method is relatively simple and the cost is relatively low. The technician is required to first measure the distance between the required openings, the position of the openings, the size of the openings and the number of openings, and then clean the oil fume pipe through these holes, and finally seal each hole. The opening method is used when the manual method and the disassembly method cannot be cleaned.

4. Cleaning method four for grease ducts: cleaning by machines

This method can be used for grease ducts that cannot be entered manually, inconvenient to disassemble, and has less oil pollution and a shorter cleaning cycle. This method is the least difficult, simple to operate, and has the least workload and lowest cost. Spray the cleaning agent in the pipeline to soften the oil and then brush it with an electric flexible shaft.

5. Grease duct cleaning method five: airborne

This method is mainly suitable for cleaning vertical oil ducts of more than 50 cm. The upper and lower cuts of the pipeline are first disassembled by the technicians, who use safety ropes to clean the dust in the flue from top to bottom. This method is more dangerous, has high technical requirements and high cost, but it has a good cleaning effect.

6. Our factory exports the whole system cleaning machines for kitchen exhaust cleaning system.

Products are kitchen exhaust cleaning machine, foam generator, oil filters cleaning machine, high pressure cleaner etc.