Five Common Methods Of Cleaning Oil Fume Pipeline

Recently, some of the kids asked about the cleaning methods of the oil smoke pipeline. In order to solve the questions, today, the small editor specially sorted out five common methods of cleaning the oil smoke pipeline. Then follow the small compilation to learn about it.

1. Cleaning method of oil smoke pipeline II: manual access

This method is suitable for parallel flue with a height of more than 40 cm. It is used for manual drilling in and cleaning. The method has a relatively high labor intensity. Ventilation and low-pressure lighting appliances should be paid attention to.

2. Cleaning method of oil smoke pipeline 3: dismantling

When there is no way to enter the oil smoke pipeline manually, the method of disassembly can be adopted. This method is the most thorough method of cleaning, but the construction is difficult, and there are many labor demands, and the cost is high. The technician first calculates the distance difference of the separation according to the actual situation of the flue, and then extends the cleaning on both sides.

3. Cleaning method of oil smoke pipeline I: Opening

This method is simpler and the cost is lower. The technical personnel in need shall first measure and calculate the distance between the required holes, the position of the holes, the size and the number of holes, and then clean the oil smoke pipes through these holes, and finally seal each hole. The opening method is used when manual method and disassembly method can not be cleaned.

4. Cleaning method of oil smoke pipeline 4: cleaning of machine and equipment

This method can be used for the oil smoke pipeline which can not be accessed manually, is inconvenient to be disassembled, and has less oil pollution and shorter cleaning cycle. This method is the least difficult and simple operation, and the workload is minimal and the cost is the lowest. Spray cleaning agent in the pipeline, and then brush the electric soft shaft after the oil is softened.

5. Cleaning method of oil smoke pipeline 5: air drop

This method is mainly applicable to cleaning vertical oil smoke pipes with a height of more than 50 cm. The top and bottom section of the pipeline shall be disassembled by the technical personnel. The technicians shall clean the dust in the flue from the top to the bottom with safety ropes. This method is dangerous, high technical requirements and high cost, but the cleaning effect is good.