Chemical cleanings for boiler tube cleaning

Due to the wide variety of methods available for different cleanings to be carried out, our professionals, have the technical means so that each work can be designed, and perform the best possible service. Among the best known methods, we have:

 By filling and circulation: it is the most efficient method normally for equipment such as boilers, exchangers, pulp digestion systems or concentrate, heat exchangers, pipes, etc. The chemical products are pumped and circulated through the system, or in some cases are left in contact during the adequate time for the dissolution and detachment of the deposits.

  Vapor phase cleaning: especially useful for difficult equipment to fill with liquids, this method uses the blowing of the appropriate chemicals in a steam vein and at controlled speed. It is particularly useful in pipes, cooling towers, tanks, over-heaters, etc.

· Total cleaning "on stream" of cooling water systems. By means of this type of cleaning, both the transfer of heat and the loss of load in the flow, can be restored throughout the system simultaneously, in addition favored because the cooling systems can be cleaned, both out of service and in operation. Practice for dirt with iron, calcareos, mud, bacteria, etc.

 Cleaning with foam .Metodology that takes advantage of the filling capacity of containers of a controlled foam and served as a means for the contact of the chemical products and the equipment to be cleaned. Special for cooling towers, large condensers, etc.